Include

[UMPIRE13]

if you need to know were the Amp is


Radio Speaker Amplifier Replacement
Removal Procedure




Cycle the folding top to reveal the body rear accessory compartment.
Turn the ignition switch to the OFF position.



Loosen the nuts and remove the lid from the body accessory compartment.
Remove the folding top control module. Refer to Folding Top Control Module Replacement in Roof.
Remove the rear relay center. Refer to Rear Electrical Center or Junction Block Replacement in Wiring Systems.
Remove the daytime running lamps (DRL) diode. Refer to Daytime Running Lamp (DRL) Diode Replacement in Lighting Systems.



Remove the 4 fasteners retaining the intermediate bracket.



Disconnect the electrical connectors to the amplifier (3).
Remove the 4 fasteners (1, 2) retaining the amplifier to the body rear accessory compartment.
Remove the amplifier from the vehicle.
Installation Procedure
Notice: Refer to Fastener Notice in the Preface section.





Connect the electrical connectors (3) to the amplifier.
Install the 4 fasteners (1, 2) that hold the amplifier to the bin.
Tighten
Tighten the fasteners to 9 N·m (80 lb in).





Install the 4 fasteners retaining the intermediate bracket.
Tighten
Tighten the fasteners to 2 N·m (18 lb in).

Install the folding top control module. Refer to Folding Top Control Module Replacement in Roof.
Install the rear relay center. Refer to Rear Electrical Center or Junction Block Replacement in Wiring Systems.
Install the DRL diode. Refer to Daytime Running Lamp (DRL) Diode Replacement in Lighting Systems.



Install the lid to the body accessory compartment.
Tighten
Tighten the nuts to 7 N·m (62 lb in).

Close the folding top.