04-25-2008, 12:11 PM
|
#397 (permalink)
|
|
Also known as Triple R
Join Date: Apr 2006
Location: Camarillo, CA.
Posts: 11,341
My SSR:
04 Ricochet, ADDCO, Eibach, Joe’s Tune, Bernie’s Kit,Air Dam, Aux Fan & Lower Radiator Supt
|
Quote:
Originally Posted by Flassh
Hi, Charlie
I'm the one doing the experimenting on this, but I should be OK I went one step further when I installed the nerf bars, with the intention of eventually putting on Eric's spoiler. See - I can be pationt. 
I cut the horizontal tubes about 2 inches from where they are welded to the vertical tubes, and inserted a sleeve. All I need to do is take off 2 bolts, slide the nerf bars off, line up where I need to cut the spoiler and reinstall the nerf bars after the spoiler is cut, painted and installed. 
You could still do that with yours, but the cutting and drilling of holes would have to be done on the truck instead of in a bandsaw and drill press. Maybe a plasma cutter? Drilling the stainless might be a bit of a challenge.
I also welded a 1/8" bar to the frame, then drilled and tapped the bar and frame so I could bolt the nerf bars on. I can go from nerfy to non-nerfy in a couple minutes.
Only problem - some of my Fanatic friends have their eyes on my nerf bars, and they're easily removed.  |
How about some pictures Ray? |
|
|
