6-Speed Gear Shift Knob F/S

[MnMsToy]

I have a lighted blue flame 6-speed gear shift knob for sale. I purchased it from Flameball for $60 and the Wire harness with LED upgrade was $16 plus shipping. Here is a link to the website where you will find a picture of the knob I am selling: FLAMEBALL Three-Color Flame Series: Blue Flame on Black

I will let it go for $30 plus shipping. It is in like new condition.

[YellowDZH]

MnMs Toy does this shifter knob have threads or does it have a set screw in it?? You know that the SSR shifter has a set screw, however I replace mine with a Hurst knob that has 16 mm thread. If you want to know how I did it, let me know.

[Focks]

How does it work? where do you plug in at? Does it only work for Standards or does it also work for Automatics?

[MnMsToy]

Originally Posted by Focks

How does it work? where do you plug in at? Does it only work for Standards or does it also work for Automatics?

The knob that I am selling is only for 6-speeds. I did not install the lighting. But at the base of the knob there is a very small hole maybe 1/8" that the LED goes in. you would run your wire thats included in the kit inside the leather boot and back to the fuse box. Seems like it should not be to difficult. Then select a hot wire associated with your headlights or whatever suits you. You could also install an on/off switch in the console.

I believe Mike in AZ has installed a lighted knob on his automatic, send him a PM.

[MnMsToy]

Originally Posted by YellowDZH

MnMs Toy does this shifter knob have threads or does it have a set screw in it?? You know that the SSR shifter has a set screw, however I replace mine with a Hurst knob that has 16 mm thread. If you want to know how I did it, let me know.

It has small set screws very similar to the OEM knob. It takes at most 5 minutes to install this knob.

[MnMsToy]

Originally Posted by YellowDZH

MnMs Toy does this shifter knob have threads or does it have a set screw in it?? You know that the SSR shifter has a set screw, however I replace mine with a Hurst knob that has 16 mm thread. If you want to know how I did it, let me know.

How did you do it?