Vette Servo

SSR95 · 06-25-2008, 02:02 PM

Does Anyone Know The Gm Part Number For The Vette Servo?

Darc_vexiS · 06-25-2008, 02:11 PM

Yeah it's Greg Ducato...

Seriously send him a PM they are extremely reasonably priced.

PIZZADOC · 08-15-2008, 12:23 AM

Greg Ducato,HAVE BEEN TO YOUR WEB SITE BUT GOT CONFUSED. WANT TO BY A VETTE SERVO AND WHO DO YOOU RECOMMEND IN THE LAS VEGAS ARE TO INSTALL.
ANXIOUSLY AWAITING ANSWER

Greg Ducato · 08-15-2008, 06:30 AM

Quote:

Originally Posted by PIZZADOC

Greg Ducato,HAVE BEEN TO YOUR WEB SITE BUT GOT CONFUSED. WANT TO BY A VETTE SERVO AND WHO DO YOOU RECOMMEND IN THE LAS VEGAS ARE TO INSTALL.
ANXIOUSLY AWAITING ANSWER

Most any trans shop can do this for you in an hour or less. We do not have the servo listed on our web site but you can call William here at the shop and he will get you fixed up.
Greg

Greg Ducato · 08-15-2008, 06:42 AM

Quote:

Originally Posted by SSR95

Does Anyone Know The Gm Part Number For The Vette Servo?

there are two parts to this, #8642115 and #8642093. I addition, you will need all the related sealing rings and o-rings for conversion.

JimGnitecki · 08-19-2008, 06:17 PM

Greg: Give him the s[peech about installing it CORRECTLY. Remember that other recent case where he though he had installed it correctly, but did not?

Jim G

Greg Ducato · 08-20-2008, 05:40 AM

We can fax or email him some SSR specific installation instructions if need be.

ssrfl1 · 08-24-2008, 02:49 PM

Just did my servo I got from Greg today.

Greg shipped it fast and the instructions were spot on, except for one BIG problem.

He forgot to mention how to stop the ATF fluid from running into your armpits.....

Otherwise took about 45 minutes to do. The hardest part was putting the retaining ring back in.

Took it out and could do a good burn in 2nd now.

Best 35-40 I spent in a while.

Greg Ducato · 08-25-2008, 05:09 AM

Quote:

Originally Posted by ssrfl1

Just did my servo I got from Greg today.

Greg shipped it fast and the instructions were spot on, except for one BIG problem.

He forgot to mention how to stop the ATF fluid from running into your armpits.....

Otherwise took about 45 minutes to do. The hardest part was putting the retaining ring back in.

Took it out and could do a good burn in 2nd now.

Best 35-40 I spent in a while.

If you tie a rag around your wrist then the fluid can't run down your arm, works on fuel and oil line replacements too.( just a little tip from the pro's) Have fun with that new modification!