Chevy SSR Forum banner

Rear Cover:

786 views 6 replies 5 participants last post by  yellow bear 
#1 ·
Has anyone removed the drop down compartment under the rear cover ? I was wondering if it has to be riveted back in place or can it be screwed back in. Will the bracket under the cover stay in place if you drill out the rivets.
 
#7 ·
The "door" appears to have a "doubler" rivited to the inside, so that there is the hinge, door, and the doubler, and the rivet goes thru all 3 pieces. I am guessing the side that is riveted to the "lid" has a doubler also. If that is the case, you will need to replace that when you re-assemble. You'll probably want to remove the whole trunk lid covering to drill out those 3 rivets. Peel back the covering inside the door at the hinge and you'll see the doubler (strap) where the rivet is "bucked".... Hope this is your answer...
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top