Jeremy Formato Tuning and Porting Feb 3rd in Ft Myers - Chevy SSR Forum
Chevy SSR Forum Chevy SSR Forum


» Log in
User Name:

Password:

Not a member yet?
Register Now!
» Auto Insurance
» Featured Product
» Wheel & Tire Center

Go Back   Chevy SSR Forum > Supporting Vendors > FasterProms


SsrFanatic.com is the premier Chevrolet SSR Forum on the internet. Registered Users do not see the above ads.
 
 
LinkBack Thread Tools Rate Thread Display Modes
Old 01-21-2009, 04:53 PM   #1 (permalink)
Senior Member
 
Join Date: Nov 2008
Location: Lutz, FL
Posts: 119


My SSR:
99 FRC Vette 480RWHP 420RWTQ NA
View JFormato's Photo Gallery
Jeremy Formato Tuning and Porting Feb 3rd in Ft Myers

Hello all, Jeremy will be tuning and porting in Ft Myers on Tuesday Feb 3rd at:
Aftermath Performance
2940 Hanson St
Fort Myers, FL 33916
(239) 939-4649

The cost of tuning is $400 + $100 per hour for the dyno. If you are just looking for a street tune , that can also be done for $300 w/ WB o2. We work very hard on each and every vehicle until every customer is happy and the vehicle is spot on.

The average gain for the LS2 intake manifold is 11rwhp/13rwtq. We have done over 320+ LS2 INT manifolds, 90+ LS7s 18RWHP and 20RWTQ, 35+ LS3 & L76s 12RWHP and 15RWTQ and over 325+ TB's.We have had many cars gain much more than the averages listed: 20RWHP from an LS2, 32RWHP for an LS7, and 30RWHP from a L76 and 22RWHP from an LS3. When porting the TBs you will feel greatly improved throttle response and in the bottom end/mid range a strong seat of the pants increase. Many liken the difference to taking about 350lbs out of the vehicle. It truly makes the car much more fun to drive. Our Manifolds are very thoroughly ported not only in the runners but also much of the plenum and TB flange are enlarged in order to support more airflow from idle thru the upper RPMs. The larger the air reservoir the less likely it is to deplete the greater volume in the upper RPMs. Hence the difference of the '00 LS1 intake vs the '01 LS6 intake, a small plenum volume change gained 10RWHP and 10RWTQ.

This is all on a core exchange basis.




To schedule a time, please call us at 813 476 7364 or Jeremy on his cell at 813 495 8778.
JFormato is offline  
Sponsored Links
Advertisement
 
Old 01-21-2009, 05:12 PM   #2 (permalink)
Senior Member
 
Join Date: Nov 2008
Location: Lutz, FL
Posts: 119


My SSR:
99 FRC Vette 480RWHP 420RWTQ NA
View JFormato's Photo Gallery
Here are some graphs of some cars that we dynoed, tuned, and swapped the intakes and TBs. Some are direct A-B swaps and show the results. Some are Base runs then a rough tune and then we swap the intake and TB, and then fully optimize the tune.

1st is a Stk 07 LS7 ported and tuned: 1st is base, 2nd is base tune, 3rd is ported and tuned completely.


Here is a bolt-on 07 LS7 (w/ headers CA)I base tune and then ported and tuned.


Here are two C6 LS2's with just cai and cat backs before and after tune and Ported intake and TB:




383 LS6 to ported FAST and nice set of heads:


408 LS6 to ported FAST:



Obviously the larger motors wanted the larger manifold more than a smaller motor but we have had an LS2 with one of our ported LS2s on it Put a ported FAST on there and pick up 22RWHP and 30RWTQ on a 6L bolt-on 07 vette.
JFormato is offline  
Sponsored Links
Advertisement
 
 

  Chevy SSR Forum > Supporting Vendors > FasterProms


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools
Display Modes Rate This Thread
Rate This Thread:

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Powered by vBadvanced CMPS v3.2.2

All times are GMT -6. The time now is 07:05 AM.



Powered by vBulletin® Version Copyright ©2000 - 2012, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.3.2