Chevy SSR Forum banner
  • Hey everyone! Enter your ride HERE to be a part of this month's Ride of the Month Challenge!
1 - 17 of 17 Posts

·
A Little BIG JIM
Joined
·
3,352 Posts
Apply heat with a hair dryer on Hi hold about 16" away from emblem for 30 -40 seconds then use a plastic putty knife to pry emblem off (instructions as per shop manual)

Good Luck,
BIG JIM
:cool
 

·
Premium Member
Joined
·
3,603 Posts
BIG JIM said:
Apply heat with a hair dryer on Hi hold about 16" away from emblem for 30 -40 seconds then use a plastic putty knife to pry emblem off (instructions as per shop manual)

Good Luck,
BIG JIM
:cool

Are there any holes behind the chevy emblem?? :
 

·
Premium Member
Joined
·
3,603 Posts
Thanks Mark. :thumbs
 

·
Administrator
PEDIGREE SSR
Joined
·
8,793 Posts
Heritage Look for me!

Mofo said:
Has anyone taken the Chevrolet Bow Tie emblem off of the tailgate? Mofo
rj5620 said:
I like the clean look without both the Chevy and SSR logos.
Just my feelings... I have always been one for the great Chevrolet's heritage look the awesome bowtie ...

and that
SSR logo!
 

·
Premium Member
Joined
·
3,603 Posts
Rear Bowtie

Marc NY said:
OH OH
hmmmmm gosh I had thought that both logos were attached with the great tape!

I think there attached with tape but have guide holes for installation purpose's. :rant
 

·
Premium Member
Joined
·
1,338 Posts
Emblems

:) :)

The Chevy Bowtie and SSR emblem are attached to the tailgate with double faced tape. The Bowtie has two prongs that are guides that fit into holes in the tailgate.

As well, the "SS" has two prongs and the "R" has two prongs. In all there are 6 holes in the tailgate.

I removed and reinstalled mine when it was painted.
 
1 - 17 of 17 Posts
Top