Chevy SSR Forum banner
1 - 1 of 1 Posts

· Registered
206 Posts
Discussion Starter · #1 ·
I am in the process of installing my new compass/outside temp/altitude gage and would like to hard wire it in place since it defaults to the barometric pressure rather then altitude. It is installed on the left lower windshield and the wire will run under the dash to a convent point. Has anyone located a good B+ voltage location like the cigarette lighter in the ash tray area, and how did you get to it? Does the whole ash tray assembly removable?
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.