Chevy SSR Forum banner
1 - 1 of 9 Posts

· Retired GM Program Manager/ Chief SSR Engineer
550 Posts
The heavy rattle that sounds like "loose lumber" can be fixed by adjusting the rubber stop on the main roof linkage. That sounds like what you have. If you open the toneau and look an the main roof linkage that is attached to the bulkhead behind the seats there is a large rubber bumper that should be pressing on a flat steel plate. All of this is part of the linkage near the large hydraulic cylinder. When the roof is up this bumper should be in firm contact with the plate. There is one on each side and both have to have pressure. You can apply heavy duty polypro tape to the plate rather than actually adjust the bumper to get the pressure. If you adjust it too tight the roof will not fully close.
1 - 1 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.