Chevy SSR Forum banner
1 - 1 of 11 Posts

· Registered
347 Posts
is the shimmy when you touch the brakes ,or at certainspeeds and then go away and come back at higher speeds or does the wheel sort of jerk to one side at slow speeds

1 shimmy when you start to apply the brakes would be caused by warped brake rotors caused by possibly going thru apuddle when brakes were hot
2 a vibration that comes in at a certain speed and goes away as speed increases ,and then comes back at twice the speed of initial vibration could be caused by bad wheel balancing
3 if driving at low speed and you let go of sterring wheel and the wheel moves to either side in slight pulses or jerking motion , this would be caused by a separated belt in the tire that would cause the vehicle to drive like it was driving on a cork screw
1 - 1 of 11 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.