Chevy SSR Forum banner
1 - 1 of 9 Posts

· Registered
84 Posts
I had the same mark on my ssr I found after some inspection as the top went down it was rubbing on a piece of plastic held in with plastic clips. The clips on mine were loose I just tighten the clips up and cleaned the mark up and it has not been marked up since. So put the top down slow and have another person watch as to where it is rubbing well good luck hope this helps
Mike :)
1 - 1 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.