Chevy SSR Forum banner
1 - 1 of 1 Posts

·
OP
Joined
·
8,278 Posts
looked everywhere

Well I checked the Helms repair manual and could not find it anywhere, found what the connector looks like and the schematics, but no diagram.
So I climbed into my SSR and the best I can tell is that the harness runs into the inside of the lid bracket (like a brake line into a fram rail) and that was as far as I could reach, but it appears it goes behind the plastic bed liner as well. Mine is carpeted so obviously it goes behind it too.
I would begin by just pulling and peeking behind the plastic on that side, perhaps you will see the connector.
Sorry I wasn't more help, good luck.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top