Chevy SSR Forum banner

1 - 11 of 11 Posts

·
Proud Original Owner
Joined
·
18,065 Posts
Where can I get the letters
Here's a link;
 

·
Registered
Joined
·
2,813 Posts
I tried and failed at getting them on right. I got as far as the V and messed up the R so pulled it all back off and gave up.
 

·
Registered
Joined
·
2,701 Posts
I tried and failed at getting them on right. I got as far as the V and messed up the R so pulled it all back off and gave up.
One of my favorite saying about dealing with vinyl products is.... it's easy to do, but it's even easier to mess it up.
 

·
Two Tone Owner
Joined
·
2,576 Posts
Discussion Starter #10
I tried and failed at getting them on right. I got as far as the V and messed up the R so pulled it all back off and gave up.
I took the emblem off the R and did the installation on the kitchen table.
I heated the emblem with a hair dryer for Only about 3 or 4 inches and then put the inserts on and then heated the next area and so forth.
They went on fairly easily but you have to be careful with the alaignment of the insert.
I was afraid they would not stick, so went on the interstate for a few mile at about 75 MPH.
But they stayed on OK.
The big test will be in January when I drive 1050 miles to Florida. That should test the glue on them.
Walter
 
1 - 11 of 11 Posts
Top