Chevy SSR Forum banner
1 - 10 of 10 Posts

· Registered
Joined
·
724 Posts
Discussion Starter · #1 ·
What the hell is this? A bit more than I want to spend though:

Click this
 

· Premium Member
Joined
·
3,827 Posts
:agree
 

· Registered
Joined
·
724 Posts
Discussion Starter · #4 ·
no one else has an opinion on this?
 

· Machell
Joined
·
22,391 Posts
what kind of opinion were you looking for? I think if you want to spend that much money do it. They have a good rep so I am sure they would do a good job. I wouldn't spend that much on that engine and have no where to drive it, what a waste!
 

· Registered
Joined
·
724 Posts
Discussion Starter · #8 ·
I want to know what the hell are they doing to the car for almost $30k!!! last I spoke to them the guy said adding a supercharger would cost around $8k installed. How are they able to get 500 out of this engine? And if they can why the hell didn't GM push a bit harder to give us more HP?
 

· Registered
Joined
·
172 Posts
They must be doing some serios massaging to bring the engine up to 427 CID. The stock motor comes in at 326 CID. I would be worried about cracking a cylinder wall.
 

· Registered
Joined
·
1,719 Posts
IIRC they are putting new sleeves in the block.

I haven't thought about the 72 Vega that was my first car. An aluminum block, but unsleeved. Lasted till the head gasket leaked. Then cost $400 to have the block bored out and sleeved.
 
1 - 10 of 10 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top