Joined
·
60 Posts
I installed REAR SPRINGS only yesterday. They were BellTech springs for Trailblazer that I got from forum member Axiom .
Measurements from floor
I only wanted to lower the back a little. This is my everyday driver and I've been down the bumpy and hugh turning radius before. In the past I've installed drop spindles and/or different A-arms, expensive shocks, etc. to compensate but nothing lives up to the factory ride/turning. For best looks I would drop both front & back.
Just my preference.
George
Measurements from floor
- Before = 31
- After = 29 1/2
I only wanted to lower the back a little. This is my everyday driver and I've been down the bumpy and hugh turning radius before. In the past I've installed drop spindles and/or different A-arms, expensive shocks, etc. to compensate but nothing lives up to the factory ride/turning. For best looks I would drop both front & back.
Just my preference.
George


