Chevy SSR Forum banner
1 - 2 of 2 Posts

·
Premium Member
2004 custom Paint and trim , ROTM winner #2, Previous owned R’s, 2006 #1 of 8 2 tone & 2005 silver
Joined
·
2,846 Posts
Discussion Starter · #1 ·
Just about done doing some rear suspension upgrades. Mikes lowering springs, bars and shocks. Adjustable panhard bar. Powder coated associated pieces.
 

Attachments

·
Premium Member
2004 custom Paint and trim , ROTM winner #2, Previous owned R’s, 2006 #1 of 8 2 tone & 2005 silver
Joined
·
2,846 Posts
Discussion Starter · #4 ·
It looks good, adds a lot of color and detail. Can I ask a question about the control arms and the pan hard bar? Do they tell you to tighten it up with the suspension hanging or to tighten it when it is sitting under load? All of the ends have polyurethane ends in them don't they? If so it may not make any difference as the sleeves usually allow easy swivel in polyurethane bushing. I was just curious.
Way I understand is to set it up with it on the ground. If off jack it up and adjust and try again until it’s right
 
1 - 2 of 2 Posts
Top