Chevy SSR Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
110 Posts
Discussion Starter #1
Lookin over the roof compartment today I made the following observation;

Near the top of the bulkhead, between the roof compartment and the cab (seat back area), there are some large wiring looms, the kind used to attach a harnes to the body or frame (they close around a pack of wires and lock closed)

The looms are open with no wires/hydraulic lines in place. If I was guessing I would say the factory changed the routing of the lines intended for these looms.

Anyone?
#3040:confused
 

·
Registered
Joined
·
10,950 Posts
Looms

I was wondering what those were for as well. I asked a bunch of people, but no one had a reasonable explanation. Can't wait to find out why they are there.
 

·
Retired GM Program Manager/ Chief SSR Engineer
Joined
·
549 Posts
These are used to stow the tonneau hydraulics when the top module is shipped to the Craft Centre. They have no use once the top is installed into the body.
 

·
Registered
Joined
·
10,950 Posts
looms

Well that's mildly interesting......

thanks freezer.
 
1 - 4 of 4 Posts
Top