Chevy SSR Forum banner
  • Hey everyone! Enter your ride HERE to be a part of October's Ride of the Month Challenge!
1 - 4 of 4 Posts

·
Registered
2004 Chevy SSR
Joined
·
12 Posts
Discussion Starter · #1 ·
Good morning. I’m going to be installing the Cooling System Tune-Up Bundle from Simple Engineering. Any suggestions of anything to watch for while doing this? Does the seal go on the thermostat first or in the water neck housing? I havent’t done one like this yet. I’ve always worked on 60’s type. Thanks in advance.


Like



Comment


Share
 

·
SSR Believer
Joined
·
2,638 Posts
Good morning. I’m going to be installing the Cooling System Tune-Up Bundle from Simple Engineering. Any suggestions of anything to watch for while doing this? Does the seal go on the thermostat first or in the water neck housing? I havent’t done one like this yet. I’ve always worked on 60’s type. Thanks in advance.


Like



Comment


Share
The gasket/seal has a small groove inside and it goes on the thermostat first, then the thermostat goes into housing. Don’t ask how I know this, but if you must know…


Everything else is pretty straight forward.
 
1 - 4 of 4 Posts
Top