Chevy SSR Forum banner
1 - 14 of 14 Posts

·
Premium Member
Joined
·
95 Posts
Discussion Starter · #1 ·
I just purchased an 05 SSR. I bought the tailer hitch , however I can not find any wiring harness for the trailer lights. Any suggestions?

Richard Shute :ssr :flag
 

·
Registered
Joined
·
413 Posts
left frame rail taped to harness about even with rear wheel
 

·
Registered
Joined
·
1,794 Posts
RHShute said:
I've crawled under there, however I couldn't find it. Maybe I'll pull the wheel off tomorrow.

Thanks
Richard
No need to do that, it is just wires. You have to add your own plug.
 

·
Tu-Tone club member
Joined
·
5,782 Posts
I had the dealer

dig it out and connector it up. Cost me $15. Placed it in a plastic bag and retied it to the frame rail. Done till I need it.

P/P

Peace :flag
 

·
Registered
Joined
·
110 Posts
The wire's are in a wad of black tape on driver side frame rail. On the black plastic tubing that covers the wiring, you'll see the wad of tape wrapped around it. Carefully cut with razor knife to expose the 4 wire's you'll need. As per previous post. Had 2003 & 2005 both in same place. Good Luck

Paul Perinati :ssr
 

·
OP
Joined
·
8,276 Posts
Buffy said:
HOORAY! :party

From experience now, you won't even know a trailer is back there! Great tow vehicle!
as long as it is under 2500 lbs, right??
I wish it could tow 5k lbs...
 
1 - 14 of 14 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top