Hey there Guest! Check out the current Ride of the Month contest.

View and vote on the submissions from the community fanatics vying for the coveted ROTM award!
Hey there Guest! Did you know an International Rally is coming up in September? Check out the International Rally Information here. We hope to see you there!

Trying to put the Side Saddle boxes in....

1375 Views 5 Replies 3 Participants Last post by thefalguy, May 21, 2005

thefalguy

Discussion Starter · May 18, 2005

Ok. I bought a set of side saddle boxes that were 'take-outs' of a new SSR.
I didn't have instuctions for installation, but it is not too complicated.
However, I think it was a take out from an '05 but want to know if anyone has found this issue....
The bottom rail slides in fine and the 3 point attachment is not a problem but the rail on the side of the box that the single small metal piece goes into seems to be bigger (wider) than the slot in the rail.
Anyone else encounter this?
Is the box side rail of an 05 slightly wider than an 04?
Do I just grind down the little piece of metal that the wingnut/bolt goes into so it fits into the rail?
The piece I am trying to slide in is rectangular not square. The narrowest part of this is still wider than the side rail.

Am I making sense?

Dave
:flag

Save

1 - 1 of 6 Posts

crazyrtr53

· #3 · May 18, 2005

D Ring's

thefalguy said:
Ok. I bought a set of side saddle boxes that were 'take-outs' of a new SSR.
I didn't have instuctions for installation, but it is not too complicated.
However, I think it was a take out from an '05 but want to know if anyone has found this issue....
The bottom rail slides in fine and the 3 point attachment is not a problem but the rail on the side of the box that the single small metal piece goes into seems to be bigger (wider) than the slot in the rail.
Anyone else encounter this?
Is the box side rail of an 05 slightly wider than an 04?
Do I just grind down the little piece of metal that the wingnut/bolt goes into so it fits into the rail?
The piece I am trying to slide in is rectangular not square. The narrowest part of this is still wider than the side rail.

Am I making sense?

Dave
:flag

Hi Dave

Got mine today and put them in. The metal slide bolt goes narrowest part in and curve of bolt facing inside to bed of truck so it will lock when you tighten up the D ring :thumbs Feed those in the track at the end by tailgate!!

Save

1 - 1 of 6 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month